我和闺蜜互慰高潮喷水_日韩肉丝袜免费无码aⅴ_中文字幕亚洲精品乱码_免费一级毛片毛多水多_国产精品真实露脸对白在线_久久国产欧美视频_欧美国产成人综合_色综合 另类图区_a无套内谢少妇毛片免费看看_麻豆果凍傳媒精品國產AV

If the thermal insulation decorative integrated board fails, it can be restarted after troubleshooting to ensure that the production and quality of the board are more guaranteed, so that the construction quality can be reliably guaranteed.

According to the design requirements, the spacing of each partition wall is 600mm, horizontally distributed, and the joint width is 2cm. If the scaffolding cannot be moved, leaving holes after the foundation layer is in place, the whole part should be repaired together. There should be no dry bonding between the two layers. The thickness of the soot should cover the mesh, and the surface layer of the mesh profile should not rub back and forth. The deformed joint is treated with a waterproof and heat-insulating structure. In terms of waterproofing, this thermal insulation decorative integrated board has strong waterproofness, low resistance and good moisture permeability, which can effectively reduce the mold insulation of the building wall. Rock wool has good thermal conductivity and good thermal insulation.

Due to the changes of day and night and seasons, the thermal insulation decorative integrated board will expand and contract under the influence of outdoor air and solar radiation, while the inner wall is basically not affected by this. When the temperature difference between indoor and outdoor is too large, the inner and outer walls will shrink. This repeated change makes the barrier always remain unchanged. The state is unstable and cracks are prone to occur.

We know that the main function of choosing an integrated insulation and decoration board is to prevent the heat of the floor heating coil from being lost to the ground, thus affecting the heating effect. With the protection of the insulation board, the entire heating system will be more energy-efficient. The finished coating should be well protected. When paint is used later, the contaminated parts will be covered with ribbons to avoid cross-contamination.

Before pasting, the joints of doors, windows, vents and various materials (distribution boxes, water pipes, etc.) should be covered with a 200mm wide rotating mesh. The mesh is wrapped with an insulating board, and the wire mesh is attached to each corner. Use a polymer mortar to close the holes and fold the mesh. Paste the door and window openings and connect them to the end of the wall insulation system by rotating the fiberglass mesh. The windows are made of graphite polystyrene boards, not less than 200mm on each side, and after smoothing, the insulation board is pasted.